Dave,
The modules I was built went into the TM501 single slot frame.
I used the line voltage jumper to raise the voltage from the bridge a
bit.
I also used a 6800uF capacitor on the bridge output.
I used an LM317 regulator and set its output at 22VDC.
Hope this helps!
Corby
it.
Happy holidays!
Dave
- Original Message -
From: Corby Dawson cdel...@juno.com
To: time-nuts@febo.com
Sent: Sunday, November 8, 2009 10:09:51 AM GMT -07:00 US/Canada Mountain
Subject: [time-nuts] LPRO in TM500
Dave,
I have in the past installed a number of FRSC
could do it.
Happy holidays!
Dave
- Original Message -
From: Corby Dawson cdel...@juno.com
To: time-nuts@febo.com
Sent: Sunday, November 8, 2009 10:09:51 AM GMT -07:00 US/Canada Mountain
Subject: [time-nuts] LPRO in TM500
Dave,
I have in the past installed a number of FRSC
Dave,
I have in the past installed a number of FRSC and also PRS10 into single
slot TM500 modules.
If I remember correctly I used a thick (about 1/8) aluminum plate most
of the length of the module as the mounting and heat sink.
The edge of the plate was attached to the module with screws and
