At 3:02 PM +1100 11/23/07, swingbyte wrote:
Thanks for the help - the manual is great.
I have trimmed the xtal so the control voltage is around 8.5V. The lock
output is working - drops from 1.5V to 0.03 volts when locked.
I only have an old HP5340A with OCXO option as my frequency meter. It
Hi, I've been reading this group for some time now and have recently
purchased an Efratom FRK-H unit. Now I need to make it work! I have
powered it up and after warmup it draws [EMAIL PROTECTED] I have a 10MHz
output sinewave and a lamp voltage of 8.14V. The xtal ctrl voltage is
12.2V and
Corby gave you good information. Probably you need to monitor the
resistance to ground on the lock signal for low (mine was about 140
ohms) when locked. In the manual referenced below, it looks like the
lock output is pulled up to +17V so you *would* see a voltage change if
yours had that
Thanks for the help - the manual is great.
I have trimmed the xtal so the control voltage is around 8.5V. The lock
output is working - drops from 1.5V to 0.03 volts when locked.
I only have an old HP5340A with OCXO option as my frequency meter. It
reads 10.00MHz as the output from the
I only have an old HP5340A with OCXO option as my frequency meter.
How good do you think the calibration on the OCXO is?
I have a GPS receiver I have to get going that has a 1PPS output on
it. What would be an appropriate way to use this to calibrate the
FRK - in my lifetime:)
The PPS