Hi,
The PRS 10 is now locking to the 1 PPS from the GPS.
I have checked by using an external Time interval analyser and phase
deviation between
Input and output PPS is stable. Also I can see that the magnetic MR setting
is steered.
So, the PRS10 is locking again to GPS and the MR is within the
Hi All,
I have done an experiment using the PSR10.
I have set the Magnetic offset to mid-range MO2950
Than set the Set frequency to 0 SF0. To have 0 frequency offset.
Measured the output frequency and calculate the average deviation.
By using the Frequency Synthesizer Table from Appendix A I have
Hi all,
The PSR10 is working now for 15 years at my place (total >25 years).
For the 1pps a Trimble Resolution T is used and has a good 1pps signal.
The Magnetic Offset MO is on the limit value of 2300 when using the 1pps
correction.
Therefore I think the unit is on end of life. I tried a
Hello Time-Nuts,
I am an user of a PRS10 Rubidium standard.
The unit has firmware revision 3.15.
After reset to factory settings the Time Offset (TO) was set to 1814.
Normally it was -1814. Now de PRS10 is not locking to the 1PPS anymore.
It will freeze when PL = 1. It will freeze after
