And, as of today, I still can't get it to lock. :-P
I think I'm going to have to conclude, reluctantly, that the full-size
OCXO's are simply not compatible with this unit. It strikes me as
possible there may be other hardware changes needed to run such. It's
just impossible to
Philip Jackson kirjoitti:
It's been a while since I last played with a TS2100 given the roll over issue, but IIRC
the "lock" LED is an indication that you
have more than a specified number of satellites (four sounds familiar) with a
signal reading above a certain threshold. I don't
think it
Hi!
I have TS2100 which I modified from TCXO to OCXO. I have the 'offical'
MTI OCXO, which I bought from someone on this board. I have also
replaced the GPS unit to the HEOL Design model, which was required to
get correct time at all. It's also much more accurate than the original
Trimble.
Hi
Piezo was in Carlisle rather than Carlyle PA. It was absorbed into the Corning
/ Oak
empire almost 20 years ago. Corning / Oak amalgamated with Vectron a bit over
ten
years ago.
Piezo was the original OCXO supplier on the TBolt boards. If it is a TBolt
part, just like
the later OCXO’s it
Bruce
Thanks for posting your research.
Re. the Lock question.
It's been a while since I last played with a TS2100 given the roll over issue,
but IIRC the "lock" LED is an indication that you
have more than a specified number of satellites (four sounds familiar) with a
signal reading above a