Hi Marcel,
Marcel wrote:
Could you enable debug output for ether.c and for your UDC driver and
show the results?
I enabled a lot of extra debugging messages so this is not very short.
The output attached below is including start of macb but USB device behave
the
same when I don't enable
Hi Vitaly,
Thanks so much for your reply. I got a little further now.
Marcel wrote:
Could you enable debug output for ether.c and for your UDC driver and
show the results?
I enabled a lot of extra debugging messages so this is not very short.
The output attached below is including
Hi Vitaly,
If you want to autoboot from tftp you should specify bootcmd environment
variable to something like tftp uImage; bootm.
And always use usb gadget only with network commands like tftp, dhcp,
ping, etc.
Currently it boots to the prompt. Than when I specify things like the above it
Hi Marcel,
Marcel wrote:
I have already reduced the code quite far. Basically all dma related stuff is
gone.
According to your first message in this thread I suppose that you are
using atmel_usba_udc driver. Am I right?
Looks like it's able to use PIO mode transfer (I mean linux driver).
Hi Marcel,
In addition, did you enable CONFIG_USB_GADGET_DUALSPEED option in your
u-boot config file?
With best regards,
Vitaly.
___
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
5 matches
Mail list logo