And to add, the possible bandwidth is even 61.44 MHz with the B210. The
attenuation at the band edges gets a bit higher with this mode, and it is not
too clearly mentioned in the AD9361 specs, but I am using the B210 with this
setting and have no issues with it. This clock appears being a tribut
Dear Marcus,
1. TCP works fine for my application if I am not using selector blocks. It
creates problems with selectors only for my flow graphs.
2. I have used the method of multiplying the flow with 0 or 1. It taxes
double the processing. Processing does matter when applying filters and FFT
algori
USRPs can do Tx and Rx at the same time. I did an experiment where I
modified the FPGA image of Node 2 to send the Rx samples directly to Tx on
a different freq., and measured the phase difference of the echo from Node
2 at Node 1. I didn't measure the phase difference of the carrier, rather
the
Jason,
This is perhaps a long shot but I noticed that your code does not include
set_thread_priority_safe() for each thread - only the main thread. Perhaps
adding this will help. I realize that this does not explain why you are
successful when not using the same channel.
Also, I noticed that the
Hello. I'm making a receiver for H210. I only output the first frequency
position. When the frequency is changed on the generator, it is not
displayed on the graph. Tell me what the problem is.
Thank you in advance
import numpy as np
import libpyuhd
import pyqtgraph as pg
import time
from PyQt4 im
Hello,
Can you please paste a copy of the full output, including the command, for
uhd_usrp_probe? That will include a lot of information which we can use to
offer advice.
Thanks,
Derek
On Wed, Aug 30, 2017 at 11:21 AM, L TP via USRP-users <
usrp-users@lists.ettus.com> wrote:
>
> Hi List,
> I'm
Hi List,
I'm trying to use X310 and LFRX daughter board on RFNoC frame work.
I attached UBX and LFRX boards on X310 and run command "uhd_usrp_probe" and
found that the app didn't detect antenna of LFRX, so my app can't show
signal from it.
Could you help me, please?
___
Dear Erik,
in general: No, but in a specific Up/Downlink scenario, it might work.
To explain:
The B210 indeed has two RX chains, but they are both mixed with the
*same* LO. That means that the spectrum you get can only be within the
analog bandwidth around that LO at f_RF:
spectral aspects
Thi
Hi List,
I would like to capture GSM downlink and uplink signals with USRP B210.
I have done this previously with 2 units of USRP and connected via MIMO
cable. My question, is it possible to perform this activity with USRP
B210, which already have 2 RF channels and do i have to add additional