Hi everyone,
just a quick questions: Which PoE standards are supported by the USRP
E313? I have a 802.3at PoE injector (30W) but it does not seem to boot
up (although the LED on the outside is on). Do I need more power?
Thanks in advance!
Sebastian
The issue is solved now. At first I didn't realize that the patch was
related to the build of the DDR IP component, so when I rebuilt without
clean-ing, the DDR output files were not re-built. I deleted the DDR IP
folder in the build-ip folder and re-ran the build and now it is past the
point
GRCon 2020 celebrates and showcases the substantial and remarkable progress
of GNU Radio over the past two decades. We invite developers and users from
the GNU Radio community to present your projects, presentations, papers,
posters, and problems at GNU Radio Conference 2020.
GRCon20 will be held
Hi Sebastian - The power draw of the E313 in 2x2 MIMO is peak of about 9 W
and more typically averaging around 6 W. An injector meeting the original
PoE 802.3af standard at 12.95 W at the device should be plenty sufficient.
What PoE injector are you trying to use? Do you have any others to try
Hi Kyle - Pretty much any PoE+ splitter should do the trick so long as it
can match the E320's input voltage & power plug size. Some of the Ettus
developers have tested a few stock splitters with good success. We don't
have a specific recommended device. Cheers! - MLD
On Tue, Jan 28, 2020 at 7:13
Hi,
I just successfully built an N310 rfnoc XG image (build rpt attached) with
some custom blocks using fpga-src version v3.15.0.0, but I can't load the
image successfully on the device. Below you will find four consecutive
commands (highlighted in yellow) where I do the following:
1.
