Datron 1281 DMM gives error 9005.10 Pon CI/RTx 002888 on power up.
Sometimes the DMM powers up in the working condition, but then gives error
9005.6 A-D Timeout 001940.
How to troubleshoot these errors?
Thanks
John
___
volt-nuts mailing list
I have a Datron 1281 DMM.
How to set the bias current adjustment (R222)?
How to set the offset null adjustment (R317)?
Thanks,
John Staron
___
volt-nuts mailing list -- volt-nuts@febo.com
To unsubscribe, go to
I have a Datron 1281 DMM.
How to set the bias current adjustment (R222)?
How to set the offset null adjustment (R317)?
Thanks,
John Staron
___
volt-nuts mailing list -- volt-nuts@febo.com
To unsubscribe, go to
Need the schematic of the Fluke 845AB 1993 modification.
Thanks,
John
___
volt-nuts mailing list -- volt-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow the instructions there.
When I use the SPCL Menu ADC Key I obtain the following error
A to D CORRN, Error 2008.
No other errors are listed.
What does this indicate?
After the ADC Cal I obtain the following readings with a constant voltage.
Resolution:
8 digit 10.000 106 7
7 digit 10.000
What are the values of the resistors in U3 (Resistor Network) of the
reference Module?
Where to find a 400763-1 reference module for a Datron 1281?
Thanks,
John
___
volt-nuts mailing list -- volt-nuts@febo.com
To unsubscribe, go to
Does anyone have the schematic for the Datron 1281 Reference Module?
Thanks,
John
___
volt-nuts mailing list -- volt-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow the instructions there.
These error codes 2292, 2282, 2272, 2262, 2252, 2216, and 2214 all use
the Selfcal Multiplier circuit.
I have all the error codes listed above, when doing a INT SRCE CAL.
Output at M609 pin-2 is not a dc level, therefore M609 pin-15 is a
sawtooth waveform.
Output on M609 pin-2 is a 10% duty on
What does A-D CORRN error 2008 , (no other error codes listed ) mean to
the A_D?
How to troubleshoot this error?
___
volt-nuts mailing list -- volt-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow
I am working on a Datron 1281 meter.
DC voltage calibration at 10v functions ok, but the Internal source
calibration failed.
This Meter has the following errors after Internal Source Calibration.
Error codes:
2202 1KVRange zero magnitude test (P028).
2192 100V Range zero magnitude test
On 12/28/2013 6:54 PM, Randy Evans wrote:
I am in the process of designing an upgrade for a Fluke 845 Null meter to
eliminate the opto-chopper, which doesn't work in most units today. I am
planning on using the Linear Tech LTC2054 zero drift op amp and power it with
two 3V lithium batteries
11 matches
Mail list logo