Vibrating capacitor non contact field probe in feedback loop to create a
voltage follower:
https://www.monroe-electronics.com/ESD/pdf/244a_m.pdf
Bruce
>
> On 23 March 2018 at 15:12 Neville Michie wrote:
>
> Improvise by holding a metal disk over an electronic
Improvise by holding a metal disk over an electronic balance and measuring the
force of attraction.
Calibrate it with a lower known voltage.
cheers,
Neville Michie
> On 23 Mar 2018, at 12:58, Dr. David Kirkby
> wrote:
>
> On 23 March 2018 at 01:49, kc9ieq via
I guess I don't see what the issue is. No, impedance is not infinate when not
nulled, but this is why V supply #2 Is adjustable by whatever convenient means.
Rough adjust, connect, adjust for null, measure. Rinse and repeat. If it
were my project, I'd just run up an HV transformer on a
On 23 March 2018 at 01:49, kc9ieq via volt-nuts wrote:
> How about using (or building) an additional 2kV power supply and a
> sensitive meter movement like a differential voltmeter, adjusting
> for/measuring the null? Impedance at null will be theoretically infinate,
>
How about using (or building) an additional 2kV power supply and a sensitive
meter movement like a differential voltmeter, adjusting for/measuring the null?
Impedance at null will be theoretically infinate, current will be
theoretically zero, and you can measure/monitor the voltage of your
On 23 March 2018 at 01:07, Bob Albert via volt-nuts
wrote:
> I found several electrostatic voltmeters on ebay. The brand I remember
> is Sensitive Research.
> Bob
>
So something like this?
How about using a high voltage probe that used to be commonly used to measure
anode voltages of TV picture tubes. There were probes that had a KV meter built
into the probe and there are ones that were used with VOM'S.
Joe
K3WRY
In a message dated 3/22/2018 8:59:08 PM Eastern Standard Time,
The part I struggle with is “make one” as T ohm meters are ridiculously
sensitive to things like fingerprints, for example. I had a hard time just
putting cables together that had the particular… I was going to say insulation,
but it was more than that, basically everything is important and
I found several electrostatic voltmeters on ebay. The brand I remember is
Sensitive Research.
Bob
On Thursday, March 22, 2018, 6:00:39 PM PDT, Bob Albert via volt-nuts
wrote:
What about an electrostatic voltmeter? Those have been around for decades
and draw
What about an electrostatic voltmeter? Those have been around for decades and
draw zero static current. You didn't indicate how accurate your measurement
needs to be. I am trying to recall the maker of the unit, I think ESI but not
sure.
They were somewhat popular in the 1950s as I recall
Electrostatic voltmeter?
Either the classical version or the modern electronic variant perhaps?
Bruce
>
> On 23 March 2018 at 13:33 "Dr. David Kirkby"
> wrote:
>
> I want to measure a high voltage, but put minimal load on the circuit.
> Looking at
I want to measure a high voltage, but put minimal load on the circuit.
Looking at the Keithley electrometers, the input resistance is at least 200
T ohms, but they tend to have a maximum of 200 V FSD.
A 2000 V source, and a 200 T ohm resistor gives a current of 10 pA, which
itself is easy to
12 matches
Mail list logo