, November 19, 2008 6:20 PM
To: WISPA General List wireless@wispa.org
Subject: Re: [WISPA] TVBD height requirement
Mike,
Where are you reading this on page 43?
And I've made it farther back in the report...
Is Appendix B (Final Rules) the actual rule? That doesn't look good,
see Antenna
There previously was some discussion about a 10 meter antenna height
requirement in the TVWS.
I'm only on page 43 of the report, but on this page it states that the FCC
doesn't see a need for either a height or an outdoor requirement, only a 40 cm
distance away from people. This is to comply
Mike,
On page 5 in section 8 (Fixed devices), it says fixed devices will
be required to operate with antennas mounted outdoors ...
I suppose you could run coax from a TVBD inside, but it seems like the
current method of POE to an outdoor device is preferred? So we are
still looking at
[EMAIL PROTECTED]
To: WISPA General List wireless@wispa.org
Sent: Wednesday, November 19, 2008 1:48 PM
Subject: [WISPA] TVBD height requirement
There previously was some discussion about a 10 meter antenna height
requirement in the TVWS.
I'm only on page 43 of the report, but on this page
- Original Message -
From: Mike Hammett [EMAIL PROTECTED]
To: WISPA General List wireless@wispa.org
Sent: Wednesday, November 19, 2008 1:48 PM
Subject: [WISPA] TVBD height requirement
There previously was some discussion about a 10 meter antenna height
requirement in the TVWS.
I'm
, November 19, 2008 2:34 PM
To: WISPA General List
Subject: Re: [WISPA] TVBD height requirement
Mike,
On page 5 in section 8 (Fixed devices), it says fixed devices will
be required to operate with antennas mounted outdoors ...
I suppose you could run coax from a TVBD inside, but it seems like
Mike,
Where are you reading this on page 43?
And I've made it farther back in the report...
Is Appendix B (Final Rules) the actual rule? That doesn't look good,
see Antenna Requirements on page 101. Not only is the transmit antenna
limited to 30 meters high, but the receive antenna must
You could have a lower gain omni as just a sense antenna.
- Original Message -
From: John Valenti [EMAIL PROTECTED]
To: WISPA General List wireless@wispa.org
Sent: Wednesday, November 19, 2008 5:20 PM
Subject: Re: [WISPA] TVBD height requirement
Mike,
Where are you reading
With the cost and loss's of RG6 cable, it might sense to have all the
active stuff inside.
John Valenti wrote:
Mike,
On page 5 in section 8 (Fixed devices), it says "fixed devices will
be required to operate with antennas mounted outdoors ..."
I suppose you could run coax from a TVBD