RE: [WISPA] tranzeo challenges

2007-12-14 Thread Larry A Weidig
suggestion was to reset the unit to factory defaults and set it up again. This has not helped on our instance. -Original Message- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Marlon Schafer Sent: Thursday, December 13, 2007 10:03 AM To: WISPA General List Subject: Re: [WISPA

Re: [WISPA] tranzeo challenges

2007-12-13 Thread Joe Miller
Go to radio shack or a local electronics store and get a 24 volt dc power supply. That should make up for the voltage loss in the long cable run. --- [EMAIL PROTECTED] wrote: We have a connectorized tranzeo AP set up to feed a couple clients. We've gone through a couple AP radios that have

Re: [WISPA] tranzeo challenges

2007-12-13 Thread Clint Ricker
If you haven't already, it would probably be worth: 1. Checking whether the port is showing up on a physical layer (do you have link on the switch?) 2. Check whether you are seeing mac addresses on the port (on Cisco switches, show mac-address-table). This does require a managed switch. -Clint

Re: [WISPA] tranzeo challenges

2007-12-13 Thread Marlon Schafer
I've got one doing a similar thing. Every time a change is made to the unit (two of them now) it shuts off it's ethernet port. Today I'm going to install a different switch. I'm also going to make sure that the other radio on that mast and the switch are on the same surge protector in case

Re: [WISPA] tranzeo challenges

2007-12-13 Thread Marlon Schafer
- Original Message - From: Clint Ricker [EMAIL PROTECTED] To: WISPA General List wireless@wispa.org Sent: Thursday, December 13, 2007 8:24 AM Subject: Re: [WISPA] tranzeo challenges If you haven't already, it would probably be worth: 1. Checking whether the port is showing up