-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Hello Michael,
I downloaded the RPM for at and then issued the following commands: rpm -e at rpm -i at as of now, the rpm --verify at gives me the following: .M...... /var/spool/at/.SEQ When I compared the file .SEQ with the rpm file, I noticed that the rpm file has permissions of 700, while the file had 600. I changed it to 700, the rpm --verify at now gives no error, but atd still fails on startup. I did the same verify command on another 7.1 system which it works, and got the same output as above. Doing the rpm --verify XFree86-xfs yields the following: S.5....T c /etc/X11/fs/config Again, this is identical to another, working system. JBB D Wednesday, October 17, 2001, 9:13:14 PM, you wrote: MS> On 2001-10-17, Jonathan B. Bayer wrote: >>I have a number of systems all cloned from the same disk. I have a >>problem on them in which atd fails during startup, and when I try >>starting it by hand using the "service atd start" command, it also >>fails. >> >>Additionally, xfs has a similar problem in which it starts, but for some >>reason exits. >> >>In the log I see the following: >> >>atd: atd startup failed MS> Hmmm, what does "rpm --verify at" give? MS> _______________________________________________ MS> Seawolf-list mailing list MS> [EMAIL PROTECTED] MS> https://listman.redhat.com/mailman/listinfo/seawolf-list - -- Best regards, Jonathan mailto:[EMAIL PROTECTED] -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.0.6 (MingW32) Comment: For info see http://www.gnupg.org iEYEARECAAYFAjvOPjMACgkQxQhxe/20cF6eugCeKU9DLckUEBNZGMrtC0+4IQme 7BcAnjrr86D6nvZQjWEKqK4RE8c1ZG0V =+Zp1 -----END PGP SIGNATURE----- _______________________________________________ Seawolf-list mailing list [EMAIL PROTECTED] https://listman.redhat.com/mailman/listinfo/seawolf-list
