-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 How about using SSH instead of telnet for starters? Then maybe a two-factor authentication method using AAA, say an RSA server?
- -----Original Message----- From: John Canty [mailto:John.Canty@;Vibro-Meter.com] Sent: Tuesday, November 05, 2002 2:23 PM To: Naman Latif; [EMAIL PROTECTED] Subject: RE: Protecting PIX Firewall at the Perimeter Router I have the same config here 1720 perimeter and pix 515e. The pix can be set to receive telnet and pdm from one and only one IP and you can also set the interface on which it will see that IP. The router, I am less familiar with. I believe you may be able to do the same. The only downside is this gives you limited options on management. I.E. you can only use one computer on the inside network to manage these devices, or on the router use the aux port, and on both devices use the console port. If you are in the field and a device chooses to tank out on you then you could be in trouble. Multitech and other vendors do sell RAS servers you could allow it's IP as a telnet friendly IP, but this also opens up the possibility of someone dialing into this thing and messing things up. Try tossing one of these things on a pbx analog line with an extension and you may have a good solution there. Just like anything else, eliminate needless variables, but keep your options open. Set up gates that one must overcome in order to gain access. //John - -----Original Message----- From: Naman Latif [mailto:naman.latif@;inamed.com] Sent: Monday, November 04, 2002 8:47 PM To: [EMAIL PROTECTED] Subject: Protecting PIX Firewall at the Perimeter Router Hi All, I wanted some suggestions\practical experiences for protecting a Firewall wall at the Perimeter Router Level. We have a PIX Firewall connected to our Cisco Router, which is connected to the Internet. Should there be any IOS Firewall Rules in the Router, other than blocking Telnet,FTP etc to the Firewall itself ? PIX will be doing NAT, protecting DMZ machines, and IPSec connections. Regards \\ Naman -----BEGIN PGP SIGNATURE----- Version: PGPfreeware 6.5.8 for non-commercial use <http://www.pgp.com> Comment: http://www.parisstone.com/ iQA/AwUBPcl+V/2j5dDsq7N3EQLxeQCgvlYlc37kadEI8yslLP5ScvBy+LMAoKzb CS102oKVB/KfQYhiu3mLJ/A+ =niTj -----END PGP SIGNATURE-----
