Gonzalo:
I would not mess with this in this way. Use PDCC to make a dataless seed volume for your Guralp sensor. Then convert the dataless to RESP using rdseed (./rdseed -R -f <dataless>) Now place the RESP files at CAL/ Branden *Branden Christensen* *[email protected]* Volcan, Panama *Follow OSOP * Facebook: http://www.facebook.com/osop.panama Twitter: @OSOPSA <http://twitter.com/OSOPSA> News Blog: http://www.osop.com.pa/blog/news The Seismo Guys Blog: http://www.osop.com.pa/blog/the-seismo-guys/ On Fri, May 17, 2013 at 10:47 AM, gonzalo antonio fernandez marañon < [email protected]> wrote: > Dear Community. > Again me. Maybe now This question will be so silly for you. > I am trying to get the poles and zeros from a Guralp to Seissan fomat. > I was reading the manual for getting the response file until I get > "stop" at this point. > > Guralp Poles and Zeros: > > -23.56 x 10-3 ±j -23.56 x 10-3 0 > -62.3816 ±j 135.392 0 > -350 > -75 > > Then my NOrmalizing factor is: > 5,763 X 10^16 > > I assume that I must Multiple the Normalizing Factor with the poles > and Zeros like this: > > (-23.56 x 10-3 ) X (5,763 X 10^16) = -1357X10^14 > > (j +23.56 x 10-3) X (5,763 X 10^16)= 1357X10^14 > > IS it ok > Best Regards. > Gonzalo F. > OSC > > _______________________________________________ > seisan mailing list > [email protected] > http://mailman.uib.no/listinfo/seisan >
_______________________________________________ seisan mailing list [email protected] http://mailman.uib.no/listinfo/seisan
