Hello José,

When you use MULPLT, in single trace mode, you will see two horizontal lines on 
the left side of the screen, if you place your cursor above the top line when 
you are picking the phases,   you will mark a compression, if you mark 
underneath the lowest line you will mark a dilatation. I hope this helps. If 
you have any other question let us know. 
It is also possible to mark the polarities with multiple trace mode, just put 
the cursor high or low in relation to the waveform trace, just like you would 
in single-trace mode. It’s trickier because you don’t have the guide-lines but 
you’ll get the hang of it with trial and error. 

Best regards,

EA

On 2013/09/19, at 01:06, José wrote:

> Hi everybody
> 
> I need to get focal mechanism for local earthquakes, but I don't know how
> pick polarities. I pick P-phase with "2" and  S-phase with "8". I want to
> know what exactly do to pick "compression" or "dilatation". I tried "-" and
> "+"  in the singgle mode trace but doesn't work.  I can't understand this
> topic in  the User's guide.
> Thank you so much.
> Hope your help.
> 
> 
> _______________________________________________
> seisan mailing list
> [email protected]
> http://mailman.uib.no/listinfo/seisan

Emanuel Antunes

Integrated Master Degree (MSc) in Physics Engineering
M.Sc. Thesis - Seismology Laboratory 
Instituto Superior Técnico (IST) - Lisbon Technical University (UTL)




_______________________________________________
seisan mailing list
[email protected]
http://mailman.uib.no/listinfo/seisan

Reply via email to