Dear Celeste and Alfaro!! Thank you so much for your support, I will try both and I also figure out that with append (a1) command can also work once you have the individual s-files.
Thank you so much!! Best regards. Gonzalo F OSC 2014-11-11 13:57 GMT-04:00 Alfaro-Diaz, Richard A < [email protected]>: > Hi > > you can make a list of the waveforms with DIRF > > you can use SEISEI to merge the nine waveforms > > then you can use MAKEREA > > then AUTOREG (to register your merged waveform) > > > > Richard A. Alfaro-Diaz > > University of Texas at El Paso > > Dept. of Geological Sciences > > Msc. in Geophysics candidate > ------------------------------ > *From:* [email protected] <[email protected]> on behalf > of gonzalo antonio fernandez marañon <[email protected]> > *Sent:* Tuesday, November 11, 2014 9:43 AM > *To:* [email protected] > *Subject:* [seisan] Nine mseed files in just one s-file > > Hello > > I have a question, I tried several times to buils just one s-file that > can have the data of 9 mseed files. > > The mseed files have the same duration. > > WHen I run MAKEREA and AUTOREG it creates one file for ech mseed data > and with mulplt I can not see the nine waveforms just in one window. > > The manual mentions (in page 23) there are 3 alternatives which says > > "Alternative 3: If the files are in individual channel files, 9 waveform > files can be listed in the S-file and only one continuous database is > needed." > > sorry for the question but i did not find the example for doing a taks > like this, would you mind give me some ligths in that issue? > > Thank you for your time and best regards. > > Gonzalo F > >
_______________________________________________ seisan mailing list [email protected] http://mailman.uib.no/listinfo/seisan
