Hi,
o Tom van der Geer [05/19/09 08:46]:
Hi,
A quick not of what I've found using SipSpy for debugging my
application. I noticed that SEMS sends the ACKs to a 200 OK (+SDP) from
port 5080 (as configured), but the Via header line reads:
Via: SIP/2.0/UDP 80.95.168.133;branch=z9hG4bKN8OcdaNq
while I expected that it should also specify port 5080 in this line. All
other SIP messages from SEMS have a Via header that reads:
Via: SIP/2.0/UDP 80.95.168.133:5080;branch=z9hG4bKL8OcdaCo
could you verify that the Via in the message on the wire really is like
that? (and could you try running it with -Dstrict.addresses=true ?)
when sipSpy was released, I had this discussion with Elias, and the
result was that parameter... here is the explanation about
-Dstrict.addresses=true :
http://www.wesip.com/mediawiki/index.php/Sipspy_docu
Stefan
The ACK in response to a "407 Authentication Required" does have the
correct Via line in the header.
It's not really causing a problem in my setup, but it's not what I
expected.
I'm using v1.1 from branches/1.1 in svn with an application based om
AmB2BSession (like click2dial).
Best regards,
Tom
_______________________________________________
Sems mailing list
[email protected]
http://lists.iptel.org/mailman/listinfo/sems
--
Stefan Sayer
VoIP Services
[email protected]
www.iptego.com
IPTEGO GmbH
Wittenbergplatz 1
10789 Berlin
Germany
Amtsgericht Charlottenburg, HRB 101010
Geschaeftsfuehrer: Alexander Hoffmann
_______________________________________________
Sems mailing list
[email protected]
http://lists.iptel.org/mailman/listinfo/sems
