Hi all Actually sequoia was able to detect the failure under a low volume of transactions(5 to 10 t.p.s),but when there is a high volume of transactions (i.e 150 t.p.s) sequoia doesn't detect the failure, just hangs
JulioC. > Date: Fri, 12 Oct 2007 10:40:31 +0200 > From: [EMAIL PROTECTED] > To: [email protected] > Subject: Re: [Sequoia] sequoia 2.10 hangs > > Hi Julio, > > Julio Leyva wrote: > > Later we did another test were we just pull out the net work cable for > > one of the back ends, wait for 5 minutes and the same behavior , > > sequoia reported that both back ends were up and running, then we put > > back the cable and 2 minutes later everything went back to normal. > > > Please don't pull out the network cable. This scenario is not supported > by Sequoia. > You will always run into problems doing this. > Unfortunatly the out of the box Sequoia is not network failsafe ;-( > > I suggest using a crosslinked network connection between both > controllers without a hub or switch. > > hth > > Stefan
_______________________________________________ Sequoia mailing list [email protected] https://forge.continuent.org/mailman/listinfo/sequoia
