On Wed, 2012-08-01 at 09:57 +1000, David Leeming wrote: > Hello, > > > > I am training some teachers in PNG to set up school servers. We are > using the EPC-AT270 (brochure attached, specs on page 7) and > previously have installed X_-v0.6 with no problems at all. > > > > This time I am trying XS-0.7 but we have a networking issue. It does > not configure either of the two Ethernet ports. > > > > The EPC-AT270 has two Ethernet ports. > > > > The installation is completely default as per the wiki 0.7 > installation guide, from CD, starting with an unformatted HDD. No > errors are displayed on the screen during installation (but there is > some scrolling of data). > > > > After installing, the first symptom is that when plugging in a > computer or AP to either eth0 or eth1, the port LEDs do not light up > and no network is seen by the connecting device. > > > > When querying ifconfig –a I can see eth0 and eth1 but they have no IP > configuration. > > > > Any next steps? Meanwhile we are reverting to 0.6 which is OK on the > EPC
>>To late to run mii-tool now, or check which kernel modules were loaded. >>Or check if HWADDR was set in ifcfg-eth0|1 while having 2 nics with the >>same kernel module: http://dev.laptop.org/ticket/11678 >> Jerry mii-tool? Clicked too soon - http://www.netadmintools.com/html/mii-tool.man.html will try it _______________________________________________ Server-devel mailing list Server-devel@lists.laptop.org http://lists.laptop.org/listinfo/server-devel