Hi simon, i must corrent me.. After looking at the source code it must be possible to bind it to a specific ipaddress by using:
<bindAddress> xxx.xxx.xxx.xxx </bindAddress> bye Norman Norman Maurer schrieb: > Hi simon, > > i think thats not possible at the moment. I will have a look at > RemoteDelivery to check if its easy to hack in.. > > bye > Norman > > [EMAIL PROTECTED] schrieb: > >> Hi, >> >> I have following problem: >> >> My Mail Server hast 2 IP Adresses: >> IP Address 1: The IP Address of the Machine there are now DNS >> registered Hostnames for this IP >> IP Address 2: The Mailserver IP Address (that is moved when the >> Mailserver is moved to a bachup machine etc.) >> >> All services (POP, SMTP, Remotemanager) are bound to IP Address 2. >> Which works fine. >> >> I think since moving to 2.3.0 (not sure but i think i have the problem >> since then) When sending out outgoing Mail the Server iudentifies >> itself with IP Address 1 (there is a HELO from unknown (IP Address 1) >> in the Mail I send out. >> >> Since this Address is not resolevabel some spam aware Target >> Mailserver refuse to connect. >> >> How can I configure James to use ONLY IP Address 2. >> >> Thanks a Lot >> Simon >> >> >> --------------------------------------------------------------------- >> To unsubscribe, e-mail: [EMAIL PROTECTED] >> For additional commands, e-mail: [EMAIL PROTECTED] >> >> !EXCUBATOR:1,456bee2253071675421181! >> > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > !EXCUBATOR:1,456bf63453071787891681! > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
