Hi, all, on linux I've installed Plone 3.1.1 with ZopeSkel 1.10. The entire procedure was ok.I was able to start the instance, to access the ZMI, to create a Plone site and to access it through the web.
Then I 1. added to the buildout.cfg file two Plone products packaged as eggs: [buildout] ... eggs = elementtree Products.SimpleAttachment Products.Ploneboard ... 2. run again the buildout: [EMAIL PROTECTED] plone3]$ ./bin/buildout -No and the buildout has aborted soon after emitting the message "Installed /tmp/tmp10OYXZ/Products.SimpleAttachment-3.0.2-py2.4.egg"I've seen that a similar problem has been mentioned a few weeks ago in a post to this list, but apparently it got no reply; reference:
http://www.nabble.com/more-buildout-errors-on-Etch-td16338526s15482.htmlHowever I think that this problem is not specific to the installation of SimpleAttachment, since a similar problem occurs to me even in the installation of Products.Ploneboard, if I put this package before the other one in the eggs list of the [buildout] section; in this case the installation is aborted earlier but the last lines of the error trace are the same.
I attach a text file with the console output that I got by running again the buildout above, with more options:
[EMAIL PROTECTED] plone3]$ ./bin/buildout -No -vvvv -DThe output is quite long, but I hope it can allow someone to understand what is going wrong. PS: now I've abridged it a little since the list doesn't accept messages over 40 KB.
Thank you very much for any help. Giovanni Toffoli
plone3_buildout_exec.abridged.log
Description: Binary data
_______________________________________________ Setup mailing list [email protected] http://lists.plone.org/mailman/listinfo/setup
