Op 28-07-10 14:33, floseries schreef: > > In addition I've found in ZMI /Control_Panel/Products that my_product has > been installed once as > Products.my_product > and once as > my_product
I can think of two possible reasons for this and the double mention in the QI: - At first my_product was in a directory that was used by the zope instance as a products directory (for example using plone.recipe.distros if you are using buildout) but now my_product has been 'eggified' into Products.my_product. The Control panel and QI have not realized yet that those two are really the same product. The likely solution for this is: remove those two products from Control_Panel/Products (or remove all products, which is normally safe to do) and restart your zope instance. Check Control_Panel/Products again and see if this product is reported double again. - Products.my_product has both an Extensions/Install.py and a GenericSetup profile. Or the GenericSetup profile is registered in the old way in python code instead of zcml (or it is registered as both). Registering the profile of a package with the Products namespace in python code means you get a profile name like 'profile-my_product:default'. Registering it in zcml, means you get a profile name like 'profile-Products.my_product:default'. So switch to zcml only and see if that helps. If not, you may need to go to the Contents tab of the QI and remove one or both of the instances of (Products.)my_product. It is probably good to reinstall the product after that. Make sure you have a backup of course. :-) Note that this is not really a big problem: nothing goes wrong, it is just annoying and confusing. -- Maurits van Rees Programmer, Zest Software _______________________________________________ Setup mailing list [email protected] http://lists.plone.org/mailman/listinfo/setup
