RE-version message texte, dsl pour le pricedent j'avais oublii.

Bonjour Miod,


j'ai ressorti un O2 de la cave...et me suis mis ` vouloir installer OpenBSD
5.1 version current depuis l'iso du dossier snapshot que j'ai gravi.

L'installation dimarre mais se stoppe comme tu pourra le constater plus bas.

J'ai mis le hinv, un printenv puis une copie d'icran du diroulement de
l'installation en mode console.

J'isphre que tu pourras y voir clair.

Merci d'avance,

Stiphane

> hinv
                   System: IP32
                Processor: 200 Mhz R5000, with FPU
     Primary I-cache size: 32 Kbytes
     Primary D-cache size: 32 Kbytes
     Secondary cache size: 1024 Kbytes
              Memory size: 256 Mbytes
                 Graphics: CRM, Rev C
                    Audio: A3 version 1
                SCSI Disk: scsi(0)disk(1)
               SCSI CDROM: scsi(0)cdrom(4)


> printenv
AutoLoad=Yes
diskless=0
dbaud=9600
volume=80
sgilogo=y
monitor=h
TimeZone=PST8PDT
netaddr=192.0.2.1
crt_option=1
SystemPartition=pci(0)scsi(0)disk(1)rdisk(0)partition(8)
OSLoadPartition=pci(0)scsi(0)disk(1)rdisk(0)partition(0)
OSLoader=boot
OSLoadFilename=bsd
console=d
ConsoleOut=serial(0)
ConsoleIn=serial(0)
cpufreq=200
eaddr=08:00:69:0c:b1:b9
videostatus=illegal_env_var
kernname=pci(0)scsi(0)disk(1)rdisk(0)partition(8)/boot
>




OpenBSD/sgi-IP32 ARCBios boot version 1.1
arg 0: pci(0)scsi(0)cdrom(4)partition(8)sashARCS
arg 1: OSLoadOptions=mini
arg 2: ConsoleIn=serial(0)
arg 3: ConsoleOut=serial(0)
arg 4: SystemPartition=pci(0)scsi(0)disk(1)rdisk(0)partition(8)
arg 5: OSLoader=boot
arg 6: OSLoadPartition=pci(0)scsi(0)disk(1)rdisk(0)partition(0)
arg 7: OSLoadFilename=bsd
Boot: pci(0)scsi(0)cdrom(4)partition(0)/bsd.rd.IP32
9048320+576072 [91+208608+125186]=0x97f6d0
ARCS32 Firmware Version 1.10
Found SGI-IP32, setting up.
Initial setup done, switching console.
[ using 334728 bytes of bsd ELF symbol table ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
        The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2012 OpenBSD. All rights reserved.
http://www.OpenBSD.org

uvm_km_kmem_grow: grown to 0xc000000010000000
OpenBSD 5.1-current (RAMDISK-IP32) #123: Tue May 22 00:23:34 MDT 2012
    dera...@sgi.openbsd.org:/sys/arch/sgi/compile/RAMDISK-IP32
real mem = 268435456 (256MB)
rsvd mem = 7020544 (7MB)
avail mem = 242704384 (231MB)
mainbus0 at root: O2
cpu0 at mainbus0: MIPS R5000 CPU rev 2.1 200 MHz, R5000 based FPC rev 1.0
cpu0: cache L1-I 32KB D 32KB 2 way, L2 1024KB direct
clock0 at mainbus0: ticker on int5 using count register
macebus0 at mainbus0: crime rev 10.1
com0 at macebus0 base 0x00390000 irq 4: ns16550a, 16 byte fifo
com0: console
com1 at macebus0 base 0x00398000 irq 4: ns16550a, 16 byte fifo
dsrtc0 at macebus0 base 0x003a0000: DS1687
macepcibr0 at macebus0 base 0x00080000 irq 7: mace rev 1
pci0 at macepcibr0 bus 0
ahc0 at pci0 dev 1 function 0 "Adaptec AIC-7880" rev 0x00: irq 8
ahc0: Host Adapter Bios disabled.  Using default SCSI device parameters
scsibus0 at ahc0: 16 targets, initiator 7
sd0 at scsibus0 targ 1 lun 0: <SGI, IBM DCAS-32160W, S62A> SCSI2 0/direct
fixed serial.SGI_IBM_DCAS-32160W_F2518354_
sd0: 2049MB, 512 bytes/sector, 4197405 sectors
cd0 at scsibus0 targ 4 lun 0: <TOSHIBA, CD-ROM XM-6201TA, 1037> SCSI2
5/cdrom removable
ahc1 at pci0 dev 2 function 0 "Adaptec AIC-7880" rev 0x00: irq 9
ahc1: Host Adapter Bios disabled.  Using default SCSI device parameters
scsibus1 at ahc1: 16 targets, initiator 7
mavb at macebus0 base 0x00300000 irq 6 not configured
mec0 at macebus0 base 0x00280000 irq 3: MAC-110 rev 1, address
08:00:69:0c:b1:b9
nsphy0 at mec0 phy 8: DP83840 10/100 PHY, rev. 1
mkbc0 at macebus0 base 0x00320000 irq 5
power at macebus0 irq 5 not configured
gbe0 at mainbus0: device has not been setup by firmware!
boot device: sd0
ahc0: target 1 using 16bit transfers
ahc0: target 1 synchronous at 20.0MHz, offset = 0x8
root on rd0a swap on rd0b dump on rd0b

Trap cause = 2 Frame 0xc000000007773738
Trap PC 0xffffffff801e2840 RA 0xffffffff801e2914 fault 0x100f8
buf_rb_bufs_RB_MINMAX+0x48 (c0000000077738b0,10000,1000,11)  ra
0xffffffff801e2914 sp 0xc000000007773890, sz 0
buf_rb_bufs_RB_FIND+0x2c (c0000000077738b0,10000,1000,11)  ra
0xffffffff801dcb24 sp 0xc000000007773890, sz 32
getblk+0x94 (c0000000077738b0,10000,1000,11)  ra 0xffffffff80260734 sp
0xc0000000077738b0, sz 384
ufs_bmaparray+0x134 (c0000000077738b0,10000,c0000000044de378,11)  ra
0xffffffff801ec844 sp 0xc000000007773a30, sz 192
VOP_BMAP+0x34 (c0000000044eba50,174,0,c0000000044de378)  ra
0xffffffff80263e94 sp 0xc000000007773af0, sz 64
ufs_strategy+0xac (c0000000044eba50,174,0,c0000000044de378)  ra
0xffffffff801ec960 sp 0xc000000007773b30, sz 48
User-level: pid 1
stopped on non ddb fault
Stopped at      buf_rb_bufs_RB_MINMAX+0x48:     ld      v1,248(a1)
ddb>

Reply via email to