Hi all, There are some parts I've been hoarding that I will not need for my 86 GLHS restoration. Pictures of these parts are at:
http://www.chrispitude.net/index.php?album=cars%2Fglhs%2Fparts_for_sale&dispsize=800&start=0 All parts have new/never used except for the cam. Some notes: 0840 is a complete, unused MAP relocation kit. 0827 is an extra MAP sensor of some sort. 0832, the windage pan, has very slight surface rust and would clean up with steel wool. 0844 is a never-used refurbished Mopar GLHT/GLHS power module. 0845 is a TAFT Stage 2 cam, and will come with the cam hardware in 0861. 0848 is an LRE anodized aluminum underdrive pulley which it pains me to get rid of. It comes with the proper belts. It will fit the older engines, but not the common block. 0849 are logic module terminals if you wanted to rebuild the 50-pin connectors. 0859 is a dual pod L-body gauge cluster. 1175 is everything needed to convert a 525 to heim joints. I got one-piece ball joints, because it's a total PITA to try to assemble spacers, washers, heims, bolts, etc. while contorting in terrible ways. The ball joint heims already have a spaced shoulder, so you just put them through the bracket and tighten the nut. It includes stowe-type locknuts which will not loosen over time. I also chose a weatherproof booted joint for the lower 15mm one that tends to see road spray. Everything you need to assemble a complete replacement linkage set is here. Please make me an offer (including shipping) on any of this stuff. - Chris ___________REMOVE-FOOTER-WHEN-REPLYING_________ ShelbyDodge mailing list [email protected] http://www.imagilist.com/mailman/listinfo/shelbydodge
