RE: ShopTalk: shaft pullers

[Dale Fittes]

I have a shaft puller bought from Golfsmith a couple of years a go. Awesome. Never have had any damage either to a shaft or head. Pull about 100 shafts in our short season in Sask.   Dale   -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Bernie Baymiller Sent: Friday, October 11, 2002 11:05 AM To: [EMAIL PROTECTED] Subject: Re: ShopTalk: shaft pullers   Arnie,   Since I'm a hobbyist and only pull a few heads a week, at most, I don't need all the power and durability of RK's shaft puller. I had a machinist friend make me one somewhat like TFlans drill press vise-type puller for about $40 total on a drill press vise about 8" x 9". Only, my puller has two slots...one for irons and one for woods. These are set on either side of the main screw...slightly offset from full power, but pull straight out. The jaws of the vise were removed and the L-shaped  piece of stainless with the two bored shaft holders and also the double-slotted pulling piece simply used the jaw screw holes, so no tapping was needed. I can probably take a digital photo if anyone is interested.   Things I like about this puller:   Plenty powerful screw-type. Just lean on the handle and it gets the job done. Pulls straight. Never damage a shaft with it. I began my clubmaking using a crowbar and it wasn't bad, but I don't do enough to get really good with it and would bend a tip every now and then....which is why I went to this puller. Heavy enough, durable enough and torch-proof. Don't have to oil it. I can put it on any surface and clamp it down. (Haven't built my shop yet and usually clamp it to the radial arm saw table.) A bargain price.   Things I don't like about this puller:   Wing nuts to tighten down the shaft clamp. Have to tighten with pliers to clamp solidly. Handle a little small, but OK.   I've been using this puller for 3 years and am very happy with it. May never need another one, but have to get new wing nuts pretty soon.   Bernie Writeto: [EMAIL PROTECTED] ----- Original Message ----- From: [EMAIL PROTECTED] To: [EMAIL PROTECTED] Sent: Friday, October 11, 2002 12:02 PM Subject: ShopTalk: shaft pullers   Interesting thread. How about some input as to what you believe to be the most "wanted" features of a shaft puller. What are the most disliked features? Please be generous in your comments!  Arnie