Well,
I went to Home Depot last night and got everything for about $12.00. Cost
me a little more because I couldn't find rebar, so I bought a 3 ft piece of 1/2"
round steel stock. I also used the threaded fittings on the ends of the
two legs with screw on end caps...mostly because I couldn't find glue on end
caps. I made the legs about 18" long...cut the round stock in half and put
1/2 in each leg. I figure a little extra weight out on the legs won't
hurt. I don't know if it was by design, but the screw in fitting on the
3-way elbow is a good idea. When (not if, WHEN) I break the riser arm,
it'll be easier to replace. Hope to get out to the range today if it'll
warm up some. It's been down in the 40s the past few nights
<GRIN>
Royce
-----Original Message-----In a message dated 2/6/04 4:35:27 PM Eastern Standard Time, [EMAIL PROTECTED] writes:
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]On Behalf Of [EMAIL PROTECTED]
Sent: Friday, February 06, 2004 4:50 PM
To: [EMAIL PROTECTED]
Subject: Re: ShopTalk: Specs on the Inside Approach
Any of you who are members of the FGI forum might want to check out a post describing a home-built version of the Inside Approach.
Thank you, What is FGI? How do I get there?
I've been building these and I'll add my tip. Instead of weighting with sandput a piece of rebar in each leg! easier and no need to cork and fill.
Arnie
