Keith:
The problem I have found is finding an acceptable "ferrule". I have never
found a source for these.
HStill
----- Original Message -----
Sent: Saturday, June 05, 2004 9:15
AM
Subject: RE: ShopTalk: Fat shaft
removal
Hi Keith,
I pulled a few of my son's a couple of years
ago to spine and align them
properly. I made notes, but cannot find
them. I can't spare the time to
locate it.
I found there was a
steel shaft inside the fat graphite running some 6"
above the hosel into
the hosel. The fat part did not go down
inside.
Colin
Colin Dick-
GCA Accredited
Professional Clubmaker
SpineMaster Mk.II And Spining Information
on http://members.shaw.ca/cgdick/
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On
Behalf Of Keith E.
Anderson
Sent: June 4, 2004 9:33 PM
To: [EMAIL PROTECTED]
Subject:
ShopTalk: Fat shaft removal
Aloha all! I have a customer who wants
his Fat shaft (steel shaft)
iron heads sent out for refinishing. Has
anyone here successfully
removed the heads from these irons and then
re-installed them? I am
led to believe that there is a plastic plug that
joins the head and
shaft, and I am worried that I will melt or deform it
during the
removal process. Has Billy Bob or anyone else come up with an
after
market replacement? Needless to say I am not going anywhere on this
job until I talk to someone who has done it before. TIA - Keith
Anderson
--
|
- Re: ShopTalk: Fat shaft removal Harold Still
-
