Yes Harold there is an answer, I bought from someone here on ST a spindle speed reducer, from 320 down to 160 RPM,which he had inhairded from his father when he passed away. It was in the orginal box and he bought it from SEARS which means if we're lucky we should be able to find a part number on it or the box. Lata me look tomorrow and get back to you this weekend. woops, execues my spelling misakes.
RK ----- Original Message ----- From: <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Friday, October 22, 2004 5:51 PM Subject: Re: ShopTalk: Question for RK! : Richard: : Thanks to you and Dadugally for the helpful information! Since I could not run my drill any slower than 320 and was pressed for time I cut slits in the shaft (a TTlite) and went with that. Drove a round wedge in the tip after it was installed with the eboxy to make sure of a tight fit. : Wish I could rig my press so it would run at around 200, any suggestions? : Again thanks to both of you> : : HStill : : -------------- Original message -------------- : : > Harold, our running your drill press way to fast for BuCe, PLus use plenty : > of cutting oil or some sort of cutting fulid. If the speed is too fast it : > will cause the reamer to bind up, i recommmend around no higher then 200 RPM : > for BuCe, if you are still having a problem just ship it down here to me and : > I'll do it for you, free of charge as usual, you just pay all shipping both : > coming and return. : > : > RK : > : > ----- Original Message ----- : > From: : > To: "Shoptalk" : > Sent: Thursday, October 21, 2004 4:25 PM : > Subject: ShopTalk: Question for RK! : > : > : > : RK: : > : Having problem reaming a ping BuCe Copper Iron! Wanted to ream out taper : > hosel to Par.Tip and started working up with reamer but went from .350 to : > .370 and it started grapping the sides and almost stopping the Bit which was : > running at about 350 . : > : What am I doing wrong??Never had this problem with Stainless steel! : > : Thanks in advance : > : Harold Still : > : >
