Thanks!
I was thinking along the same lines with tape or plastic film and epoxy.
I will check if I can find some of those pins, seems like a easier solution.
Regards
Mats B
Sent from my iPhone
> 16 nov. 2016 kl. 19:33 skrev Davy <[email protected]>:
>
> Golf club glue? I have always found it quite easy to use fast-set black
> shafting epoxy then stretch plastic packaging tape over the hole and position
> the head sole down so the epoxy settles down against the smooth tape. A
> modest amount of Scotch Brite or linen ferrule belt buffing and you are good
> to go.
>
>
> From: [email protected] <[email protected]> on behalf
> of Mats Bengtsson <[email protected]>
> Sent: Wednesday, November 16, 2016 8:50:58 AM
> To: [email protected]
> Subject: ShopTalk: Need to cover hotmelt hole.
>
> Hi
> I have a head with a 3 mm hole in it, probably a hotmelt hole, but I don´t
> need that, so how do I plug it?
>
> I tried with golf club glue but that was a bit too runny, so it was hard to
> get it to stay.
> Any good suggestions would be appreciated.
>
> Regards
>
> Mats B--
> Shoptalk ** Sponsored by the new Aldila Voodoo.
> Learn more at http://aldilavoodoo.com/
