Hi,
I'm new to Linux/Shorewall so forgive me if this is an obvious question. I
have successfully installed shorewall on CentOS 5 and have it working well.
I have a standard setup that includes the following zones:
net - internet
loc - local lan
dmz - for web servers
I currently have 1 ip on the internet interface. I would like to add several
more so I can DNAT incoming requests to various web servers in the dmz. I am
also using masq to allow the loc and dmz access the internet.
I searched the documentation and cannot find a specific example of this. I
tried adding additional config files in the /etc/sysconfig/network folder
for eth0. I have ifcfg-eth0 and ifcfg-eth0:0. The differences between the 2
files are there ip addresses. Then in masq file I had something like eth0:0
eth2. I rebooted to make sure all was changed and could not access the
internet on eth2. Shorewall did not complain about the config.
Thanks,
Pete
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Shorewall-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/shorewall-users
