>> SR_CONF_EQUIV_CIRCUIT_MODEL (SR_T_STRING)
>>
>> "AUTO"
>> "PARALLEL"
>> "SERIES"
>
> The BK 879B is equivalent but missing the AUTO, once again.
>
> Also the BK 879B can set (and read) a secondary mesured quantity among
> DISSIPATION_FACTOR, QUALITY_FACTOR, THETA and ESR. This would fit well
> in your model, by just adding another conf key. (and this can easily be
> added later on, when actually needed)
Oh, DE-5000 has a secondary display with those too. I just
originally was thinking about "AUTO"/"MANUAL" -type information
and when I changed it to "AUTO"/"INDUCTANCE"/... I just somehow
failed to realize that obviously the secondary measurement
setting should be exported the same way. I'll fix this in v2 of
my patch.
In DE-5000 the secondary measurements are D, Q, resistance and
phase angle. If I remember correctly, resistance is ESR in
SERIES mode and Rp in PARALLEL (I'll have to check this). Does
BK 879B report ESR regardless of the selected model?
Do you have any opinion about the name of the config key
("SR_CONF_MEASURED_2ND_QUANTITY")?
> And obviously, you can also set/get the used frequency among a list of
> supported ones.
Yes, this I already have in my driver. I used uint64_t for the
frequency and even allow listing the possible values even while
the meter does not support remote control.
------------------------------------------------------------------------------
Comprehensive Server Monitoring with Site24x7.
Monitor 10 servers for $9/Month.
Get alerted through email, SMS, voice calls or mobile push notifications.
Take corrective actions from your mobile device.
http://p.sf.net/sfu/Zoho
_______________________________________________
sigrok-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/sigrok-devel
