Hello. It this the right place to suggest a feature to be added?
I'm working with PulseView 0.4.0 in windows environment (despite all my normal activities are on linux) with a Cypress FX2 pod. I wasn't able to find the way to change channel polarity (in logic sense), so I assume the software lack this option. As an exercise, I tried demo software of Saleae Logic and USBee ZX and the feature isn't present there too (the end-of-life USBee ZX SW has an "Invert All Signals" but acting on everything is not very useful as well and also there's not a label on the channels to show if they are active low or high). I think it would be extremely useful and all HW LAs I worked with had it (also scopes). Gtkwave too offer the "Invert" option. It should be conceived to negate the signal directly at the input, before the protocol analyzers could elaborate it. It would be nice if polarity be directly indicated near the signal name. Just to mention an example where it would have been very useful, I recently had to decode a parallel nibble stream where D0..D3 and clock were active low. The protocol decoder presented me complemented numbers. Congratulations to all the developers for the very useful software and I will surely try in the future to offer my contribute. Best regards Andrea Baldoni ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e _______________________________________________ sigrok-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/sigrok-devel
