Hi Lucractius, Jason, Patrick, I have a related follow-up question which may also help the thread. In my younger days I was quite good with electronic design and I can still comprehend datasheets and related block diagrams, but there's no way I could design & build for today's high frequency clock cycles, RF etc etc.
Do you know of manufacturing businesses that can work to high level block diagrams, quote against them, perform the detailed design etc etc. For example, say I needed a board with a certain ARM processor, GPS transceiver and flash, and I can identify the specific requirements of those, can they be spec'd at that level, or is there an expectation you need designers to create the schematic? (eg. here's what I need, can you design & build it and what would 20k units cost?) Interestingly, this is the same problem people that don't understand software implementation have when they need software written, but the risk is much higher. I'm expecting there's businesses out that that specialise in this, but in searching the web on and off over the last few months I just get noise. regards, Jeromy Evans -- You received this message because you are subscribed to the Silicon Beach Australia mailing list. Guidelines on discussion: http://groups.google.com/group/silicon-beach-australia/msg/351e183e1303508d?hl=en%3Fhl%3Den No lurkers! It is expected that you introduce yourself. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/silicon-beach-australia?hl=en?hl=en
