Since the lower esophagus is close to the stomach, the ulcers could be caused by the same bacteria which causes stomach ulcers. The stomach ulcer is easy to cure with the right antibiotic.
I think silver would work if the bacteria is susceptible to the silver. (Note that some pathogens are resistant to silver.) I wouldn't know the protocol for treating it, but you could try drinking silver water or eating food with silver. If that doesn't work, perhaps the best thing would be to make a thick mixture of honey and silver (also lemon if you want), and drip it down your esophagus with a tablespoon over a period of time. (It takes only about 6 minutes to kill an organism in contact with colloid of silver.) In this way, the sticky honey will stick to your esophagus ulcer, giving time for the silver to do its job. The protocol worked for me to get rid of a sore throat using a thick honey-lemon mixture. With my head on my pillow, I dripped the honey-lemon down my throat. When I first used this technique for my throat, I felt so sick I thought I was going to die. It may have been a coincidence, but it was a turning point in my illness. The lemon has vitamin C (an antioxidant) which also helps the immune system do its job. Let me know if it works for esophagus ulcer. Regards, :) Joyce Inouye <[email protected]> On Wed, 17 Jun 1998 [email protected] wrote: > Hi, > > I have a friend that has ulcers in his lower esophagus(?). Does anyone > know if CS will help this situation and if so what should the protocol be? > > BTW I have a HVAC CS machine called the Mother Lode manufactured by Dr. > Ripley at > > [email protected] The machine can be seen at > > http://www.register.com/motherlode/ > > It operates at 15,000 vac and works very much the same as Bruce's. The > only thing I don't care for is the PH at the completion of the run. After > 2 hrs a gallon of 7-8 ppm according to the paperwork that came with it, > Tests out to 63 ppm with a TDS 1 and a ph of 3.7. ph at the start was 7.0 > and tds 1 or less. Dr Ripley's machine uses a silver plate as the cathode > and a small silver wedge as the anode. He does not recommend that you alow > a cone to jump up to this but rather keep it high enough so that you have a > visible arc during the whole process. > > Any comments would be appreciated. > > Bill > > > > > -- > The silver-list is a moderated forum for discussion of colloidal silver. > > To join or quit silver-list or silver-digest send an e-mail message to: > [email protected] -or- [email protected] > with the word subscribe or unsubscribe in the subject: line. > > To post, address your message to: [email protected] > > List maintainer: Mike Devour <[email protected]> > > -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the subject: line. To post, address your message to: [email protected] List maintainer: Mike Devour <[email protected]>
