> > connected all together in "normal" fashion > Water was room temp. > rods were in the water about 1 inch > rods were apporx. 1 inch apart > > I let it run 60 min. > > At the end of the run, the portion of the rod in that water turned gray/black. > One of the rods had a stream coming off the bottom and very small bubbles were around the rod. > I could not detect a color to the water. > > Well, did I make CS or not? What can I do to improve it? > >Sean
I think you should have a dropping resistor in series with the pos (or neg) lead. Around 1 K ohm. You mention 1 inch of water covering the rods, you should have 90% of the rods covered by the water, use hot water, distilled water a must, every 15 minutes, remove the rods & thoroughly clean them, to remove any build up of silver oxide. I don't believe that you made CS John in Australia -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the subject: line. To post, address your message to: [email protected] List maintainer: Mike Devour <[email protected]>
