Hi Christian, I am glad the information helped. I am impressed that you have your system up an running so fast.
Responding to your questions: 1. twisted electrodes are about 1 to 2 millimeters in diameter, i'd say 1.5 millimeters and about 3 centimeters long when new. After several batches they shorten in length and eventually have to be replaced. 2. When I use good water, that is the TV water, the cones stay around the wires during the entire two hours. If I use water that isn't so good, one or both cones drop away after an hour or more and then the side that drops away arcs while the other side doesn't. The cones do drop as the process continues, but as I said, with good water, they never completely leave the wires during the whole two hours. The information indicates that the wires should be within about an eighth of an inch to 3/16ths on an inch above the water. I think that is about 2 to 5 or 6 millimeters above the water. I have found that 2 or 3 millimeters seems to work for me. 3. Diameter of vessel 17.5 centimeters, height 22.5 centimeters. 4. I don't see the Tyndall effect much at all until after 30 minutes to an hour and then toward the top of the vessel only. I stir the water as you do when the batch is over. I do 1/2 gallon (US) batches at a time. After every shift I clean off the silver metal bar with a green brillo pad and I rinse out the vessel and dry it with a clean cloth or paper towel. I hope this helps Christian Warren ---Christian von Wechmar <[email protected]> wrote: > > Hi there Warren, > > Thank you very much for the accurate and very helpfull info on your CSPro > Ultra electrode setup. I really appreciate it. > > I took the time and modified my HVAC system to almost an exact copy of > yours. It is busy working right now! I'm giving it a two hour run. > > I have a fiew more questions that I am hoping you can answer: > > What is the diameter of your twisted silver electrodes? I noticed that my > small electrodes created a nice water pyramid, but after about half an hour > the tips were barely in contact with the water. Does the same happen in > your system? I lowered mine to make light contact anyway. Does your manual > say anything about this? > > Also, what is the diameter and height of your vessel? And what is the > distance of the bottom of your big electrode to the bottom of your vessel? > I'm wanting to create the same convection pattern in my setup. > > I notice also that when I check for the Tyndall effect while the system is > running, that the effect is very strong in the regions to the side of the > big electrode. But at the botom of the vessel the effect is very weak to > not-noticeable. Do you find the same Warren? > > I just finished my run on the new setup and I'm very pleased. I gave my CS > a stir in the vessel and now the Tyndall effect is visible everywhere. This > setup runs quite a bit faster and much cleaner than any other HVAC > electrode setup that I've tried. I feel that Bruce Marx has a fine design > indeed. > > Again, thank you for your help Warren! Have a great weakend! > > Regards, > Christian > > > > --------- > Christian von Wechmar > Stellenbosch, South Africa > --------- > _________________________________________________________ DO YOU YAHOO!? Get your free @yahoo.com address at http://mail.yahoo.com -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the subject: line. To post, address your message to: [email protected] List maintainer: Mike Devour <[email protected]>
