Hi, this is an excellent letter and I appreciate your reposting it as I must have missed it in the past. thnks, susan > >I have been involved with selling and making CS for 6 years and lately >have been making and selling a few devices to make the stuff as well as >the Dr. Beck blood electrifiers. I thought the letter I gave given to a >few people to get them started in making and using CS might help you. >What it does not say is that you need a source of pure DC current at 24 >to 40 volts. The units I sell use 120 volts AC and convert it to 30 >volts of ripple free DC current. Colloidal silver does not like ripple >in the DC current. You could get the job done just as well with 2 or 3 >automobile batteries hooked up in series. For what it is worth, here >is the letter. Good luck: > >Dear Friend, > > In this letter I will attempt to tell you some of the potential >ways you can use the devices Dr. Bob Beck has designed. Of course, this >is all very theoretical. I can speak of these things only as one >researcher sharing ideas with another since no one can legally make any >pronouncements of advice for anyone else's health unless they have been >licensed by the government for that purpose. It is also common >knowledge that everyone is different. Therefore, everyone will get >somewhat different results when they apply these things to their health. > The first thing I would like to tell you is what I have found to >be the easiest way to produce high quality colloidal silver. This >method is very simple and has worked every time. I have never had a >failed batch. Very few people can claim that. > The first thing is to start with 999 fine (99.9% pure) silver. >You can use silver rounds or silver wire. You can use silver of higher >purity such as 9999 fine (or 99.99% pure) if you wish, but that is not >necessary. > The next thing you need is distilled water. In an emergency you >can use tap water but it is not recommended as the size of the silver >particles will be larger and it will react with the impurities in the >water and settle out. It must, therefore, be consumed immediately. > The same thing will occur if you put salt in the water to speed >up the process. No one who really knows what they are doing would use >anything but pure distilled water. It may take a little longer but the >results are worth it. > Take a glass coffee maker pot (pick up at D.I. or Goodwill for >about $5) or similar heat resistant glass container and put the >distilled water into it. Make sure the pot is very clean. Rinse it out >with distilled water. Fill it to the desired level with distilled >water. > Place the pot on the stove and bring to a rolling boil. When it >reaches a rolling boil, turn the burner down until the water is bubbling >at the bottom of the pot but not at the top. That will cause the water >to stir in the pot which makes the process work faster and better. > Put the silver into the water so that the alligator clips are >not in the water. Put the silver electrodes somewhere between 1/2" and >1" apart. The closer together they are, the faster the process will go. >However, if they are too close together, especially if the water is not >being stirred, crystals of silver will bridge the gap between electrodes >and short the power supply out. That will not hurt the power supply but >it will stop the process of making colloidal silver. > Plug the unit in and watch the show. You will see the water >change gradually to a pale yellow then get progressively darker as time >passes. How dark you let it get is a matter of personal choice. The >longer you let it go the darker it will get until it turns a soupy brown >color. You can stop it at any time. > Store colloidal silver in clean containers. Use glass >containers if at all possible. Colloidal silver will tend to plate out >on the walls of most plastic containers. It will plate out on glass >containers too but not nearly to the degree that it does with plastic. > If at all possible, store it in dark glass bottles or in a dark >place. Silver is light sensitive. Colloidal silver is degraded by >light. > You also want to avoid letting your colloidal silver suspension >freeze. Freezing will cause the colloidal silver to settle out all or >in part. Freezing might also cause it to break the containers. > If you make a concentrated suspension of colloidal silver, you >can dilute it with distilled water. A few quarts can be diluted to make >many gallons of beautiful golden colloidal silver. Colloidal silver >stores better if it is not too concentrated. If storage space is not a >problem, I would dilute most of my batch for daily use. I would save a >small part of it in very concentrated form for use while traveling. > I would also suggest a way of dealing with major epidemics of >airborne infections. When it becomes obvious that "something is in the >air," immediately put a drop of colloidal silver in each eye. Snort >some colloidal silver up each nostril or hang upside down and put a few >drops into each nostril. Drink as much of it as you feel prompted to. >Remember, you will never be able to cause a toxic reaction with true >colloidal silver. Also put colloidal silver into any open wounds. > A really great thing to have would be a cool-mist humidifier. >The kind that uses ultrasonic sound to blast the water into small >droplets and blows them into the room air. Fill it with colloidal >silver and breathe some of that mist. It will result in colloidal >silver getting deep into the lungs. No bacteria or virus can live in an >environment with colloidal silver present. > At the same time, put the blood electrifier on your wrist and >begin "zapping" your blood. I have heard stories of people killing off >the flu or a cold in 20 minutes to two hours using that method. You >create a condition where there is nowhere in your body that the germs >can live or grow. The colloidal silver kills any germs in your eyes, >nose, sinuses, throat, lungs and esophagus. The "zapping" kills >anything that gets as far as the blood. Problem solved! > Colloidal silver can be used as a great deodorant after your >bath or shower. It can also be used as a general disinfectant but >remember, if it goes down the drain it will kill the bacteria in your >septic tank or sewer. That is not a good idea. We need bacteria to >break down the crud in sewage and killing that bacteria causes major >problems for a septic tank or for a sewage treatment plant. > With respect to the electrodes for the blood electrifier, I >would say that the ones I have included are good enough to get you >started but they will wear out and you will need something more durable. >I have not yet found a really good source for ready made electrodes that >are satisfactory for long term use. I am working on that right now and >will let you know when we have a really good solution. > Washing your wrist with soap and water increases the skin >conductivity and prolongs the effectiveness of the adhesive. I would >recommend trimming the electrodes so they are about 0.5" wide and about >1.75" long. That will give you a good contact with the skin over the >arteries without spreading the electrical charge so wide that much of it >is wasted in the skin rather than going into the blood in the arteries. >Dr. Beck recommends that the electrodes be even narrower. See the >paragraph below on making your own electrodes. > The electrodes I have thrown in are good for about 8-10 uses and >then the electrically conductive adhesive will lose its stickiness and >will dry out and lose its conductivity. You can rejuvenate its >conductivity by soaking them in water with a little salt (sea salt is >preferred) before you use them. They will not get sticky again but they >will regain their conductivity. You will have to use an ace bandage or >similar method to hold them on the pulse points. > If you wish to purchase more of the same sort of electrodes, go >to any medical supply house and ask for "repositionable TENS >electrodes." Repositionable means that they can be reused severable >times. You can use either the pre-wired or the pin-style electrodes. > You can make electrodes that can be reused indefinitely by going >to the local welding shop and getting a piece of 3/32" diameter number >316 stainless steel rod. (If you cannot find such a rod go to the local >junk yard and get a stainless steel radio antenna. It should work just >fine.) Cut off a couple of 1.5" long pieces and affix alligator clips >to one end of each piece. Wrap the other end with a strip of cotton >flannel and tie the flannel onto the little rods with thread wrapped >helically around the flannel. Dip the flannel in salt water, hold them >in place over the pulse points with elastic and grab the tips of the >wires from the zapper with the alligator clips. This is the method that >Dr. Bob Beck recommends in his paper. > To fully implement the Dr. Bob Beck program you need to procure >and use a magnetic pulse generator. This is necessary to clear the body >tissues of any remaining sources of infection or parasites. This will >prevent you from reinfecting your newly cleansed blood with crappy >critters from your body tissues. You also will be well advised to drink >a lot of water during the initial stages of cleansing your body so you >will be able to more rapidly flush the toxic debris from the dead germs >out of your system. Drinking ozonated water will dramatically enhance >this process and do other good things for your body as well. > Most of the toxic substances you will want to rid your body of >are acid in nature. Eating an alkaline diet will help in the cleansing >process. This means eating lots of fresh fruits and fresh or lightly >steamed vegetables. Potatoes are also alkaline in nature. Meats, dairy >products, and most grains are acid in nature and should be eaten >sparingly during any major cleansing project. > However, I want to make it clear that the Dr. Bob Beck procedure >will work regardless of diet. When I first knew Dr. Bob Beck, he was a >garbage-gut with many vices. His methods worked in spite of all that. >These suggestions on diet are my own observations on ways to further >enhance the process. > >Best wishes, > >Robert Sandberg >General Delivery >Kooskia, Idaho, U.S.A. [83539] >208-926-7932 >208-983-0567 (messages) >[email protected] > >Christian von Wechmar wrote: >> >> Hi there all, >> >> I would like to build a colloidal silver generator that produces TOP >> QUALITY colloidal silver. >> >> I have only recently become interested in colloidal silver (CS). Is it >> possible to build a CS-generator that is as good as those "finest quality" >> generators that are advertised on the web? >> >> It seems to me that most generators have three 9v batteries, a small >> light bulb and pure silver electrodes. Can this configuration produce the >> best quality CS? Is there perhaps a www site that has proper plans for >> these devices? >> >> If it is better to buy a ready made generator, can someone please >> recommend a good quality unit. The silver maker (http://www.sota- >> inc.com/csg/) looks ok? >> >> Can I use a silver generator with gold electrodes to make colloidal gold >> (finest quality)? >> >> And lastly, what is the exact recipe and dosage or CS? >> >> Thank you, >> Christian >> (Stellenbosch, South Africa) >> >> PS. I have posted this message on Usenet to alt.health and >> misc.health.alternative. Some folks feel that my motivation is $$$... Not >> really - A friend has had success in treating Aids in one of his staff >> members on the farm. My mom has also had good results in treating throat >> infections. But I feel that the local CS-generators are not optimal in >> their performance. I want to try taking CS for a while, but I want to drink >> the best stuff available. >> >> --------- >> Christian von Wechmar >> Stellenbosch, South Africa >> Tel: +27 21 885 1145 >> --------- >> >> -- >> The silver-list is a moderated forum for discussion of colloidal silver. >> >> To join or quit silver-list or silver-digest send an e-mail message to: >> [email protected] -or- [email protected] >> with the word subscribe or unsubscribe in the subject: line. >> >> To post, address your message to: [email protected] >> >> List maintainer: Mike Devour <[email protected]> > > >-- >The silver-list is a moderated forum for discussion of colloidal silver. > >To join or quit silver-list or silver-digest send an e-mail message to: >[email protected] -or- [email protected] >with the word subscribe or unsubscribe in the subject: line. > >To post, address your message to: [email protected] > >List maintainer: Mike Devour <[email protected]>
Life is Fragile. Handle with Prayer Susan -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the subject: line. To post, address your message to: [email protected] List maintainer: Mike Devour <[email protected]>
