On Mon, 28 Jun 1999 22:03:36 -0500, Pam Whitmire <[email protected]>
wrote:

>Today I heated the water to approx. 125 degrees,
>started the generator and at about 11 minutes I began to see tiny
>bubbles on one rod. Started timer again, and at the end of about 24
>minutes the one rod was black and starting to form some deposits on the
>end (but none were dropping in the water) the other rod was also
>blackish and beginning to mist a bit from the end. I turned it off and
>have left it alone. 

Sounds like you're making good CS. This has been my experience with a
similar setup including the timing.
 Don't sweat the finesses you'll read about until you have more
experience. What you're doing will work just fine.
                                                Chuck

If you want to steam a clam...
Make fun of his religion....
(Chuck Barris)


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]

List maintainer: Mike Devour <[email protected]>