right, so I really need to have them parallel with the edges of the
generator then as I was before. Thanks Ode. dee
Ode Coyote wrote:
The normal distance is 1 1/2"
If any part of the electrodes is closer to each other, the brew time
goes down with the PPM at auto off and the current density on those
closer parts becomes greater.
Less time, less silver.
You can reduce the current build up time by rotating the free ends
closer, then rotate them apart to parallel for PPM...or just start the
batch with some CS from a previous batch.
The closer parts will also erode away faster than the more distant.
Not the best idea for electrode longevity.
The electrode design is for even wear for maximum life, eliminating
current density "hot spots" and edge and corner ion discharge current
density concentrations.
Ode
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Instructions for unsubscribing are posted at: http://silverlist.org
To post, address your message to: [email protected]
Address Off-Topic messages to: [email protected]
The Silver List and Off Topic List archives are currently down...
List maintainer: Mike Devour <[email protected]>