Hi Wayne, When I built test equipment I would always put a LED and resistor in parallel with the fuses. If you saw a lit LED you immediately knew which fuse was blown. It works with AC or DC at just about any voltage as long as you size the resistors accordingly. A pretty neat trick to save troubleshooting time.
Best regards, Andy In a message dated 9/6/2008 3:57:01 A.M. Pacific Daylight Time, [email protected] writes: Morning Andy, <snip> What I wanted to tell you, .................... I have connected LED'S into 480, 3 phase voltage. These were indicators I needed for boiler and large motor control systems. A conventional lamp would have been safer I suppose, but would not last as long as the LED's. <snip> **************Psssst...Have you heard the news? There's a new fashion blog, plus the latest fall trends and hair styles at StyleList.com. (http://www.stylelist.com/trends?ncid=aolsty00050000000014) -- The Silver List is a moderated forum for discussing Colloidal Silver. Instructions for unsubscribing are posted at: http://silverlist.org To post, address your message to: [email protected] Address Off-Topic messages to: [email protected] The Silver List and Off Topic List archives are currently down... List maintainer: Mike Devour <[email protected]>
