At 02:34 PM 7/10/2009 -0700, you wrote:
Tel Tofflemire
Dewey, AZ.
--- On Fri, 7/10/09, Ode Coyote <[email protected]> wrote:
From: Ode Coyote <[email protected]>
Subject: Re: CS>Ionic foot baths and foot lore
To: [email protected]
Date: Friday, July 10, 2009, 5:28 AM
So, what is the dead short current limit on them?
Ode
You are protected by a 3 wire GFCI outlet adapter, I think around 3 amps,
without looking it up. I know just touching the wires together will shut
it off, No shock.
I know it is not as much as the Colloidal Master, it shuts off by either
way,
1. reaching your dialed in preset limit of PPM, 1---to--10....
or 2. just touching the electrodes together, breaks the flow of current.
## Shorting the electrodes drops the voltage to near zero so that the
current will stay constant.
Colloid Master, Silvergen and SilverPuppy all work that way.
It's also a standard current overload protection circuit on most good audio
amplifiers so you don't blow out the amp if the speaker wires get shorted.
In the CS generators, when the voltage goes below somewhere around 6
volts [or whatever the reference is, set by the dial]...to keep that
current constant.... a voltage *comparator* circuit turns the machine off.
[auto off]
The current control circuit alone, won't turn anything off.
Put an ammeter on the footbath electrodes and get how many milliamps it
puts out at dead short. An ammeter in series without a resistive load also
in series, is a dead short.
A GFCI is a last resort fail safe to prevent death should controls malfunction.
Ode
Did you get that Ode?
Tel
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Instructions for unsubscribing are posted at: http://silverlist.org
To post, address your message to: [email protected]
Address Off-Topic messages to: [email protected]
The Silver List and Off Topic List archives are currently down...
List maintainer: Mike Devour <[email protected]>
