Hi All, just an update... With the 5V experiment with the BS1... We are now 12 hours into this.
Current flow is now 42.8 uA idling, but it isn't that simple. Current reverses each minute. Upon switch, the current jumps to 48 ua then decreases over the next 15-20 seconds down to 43 ua, just from watching it, it seems to be pretty consistant. Observations: No Tyndal effect at all is noted. Probes seem to be untarnished, well maybe a little duller than they were last night when this was started, but I wouldn't bet on it :-). It would appear that this voltage / power factor just isn't going to work in any rational time frame, if at all. Bloody shame as there would be some real benefits if it did... With this in mind, late last night, I put together another controller board and transfered this experiment over to it, no changes in operational charactistics other than the few seconds it took to load the program into the new processor and switch the resistors and wires to the probes. The idea was to release the original board with the H-Bridge on it back so I could hook that back up to get some CS I could use while the low voltage experiment continued. Any comments most appreciated! Thanks & take care, Vikki. -- Victoria Welch, WV9K, DoD#-13, Net/Sys/WebAdmin SeaStar.org, vikki.oz.net "Walking on water and developing software to specification are easy as long as both are frozen" - Edward V. Berard. Do not unto others, that which you would not have others do unto you. -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: [email protected] List maintainer: Mike Devour <[email protected]>
