That seems excessive for the citric acid. That would produce over 2000
ppm silver citrate if you ran it to completion.
Marshall
Norton, Steve wrote:
You need to use powdered citric acid. I use 1/8 cup for 2 liters
water. The citric acid increases the conductivity of the solution so
you cannot use an automated CS generator. Also if the generator uses
current limiting it will take a long time to get to a high ppm. A
manual setup without current limiting is best. Also, a battery powered
setup may not have enough current capability.
- Steve N
----- Original Message -----
From: [email protected] <[email protected]>
To: [email protected] <[email protected]>
Cc: Norton, Steve
Sent: Wed Nov 25 23:08:58 2009
Subject: Re: CS>Use of high ppm CS
Hummm. How much and what kind of citric acid? Lemon juice or vinegar
do?? Would the high ppm be ok to drink or just gargling or spraying on
your skin??
Leslie
---- "Norton wrote:
> Silver citrate is made by adding citric acid to the distilled water
before making CS. It allows you to make high ppm silver citrate.
> I read on silvermedicine
http://www.silvermedicine.org/h2o2archives.html about using CS plus
H2O2. I think you would need to mix the two just before use. Or try
H2O2 with 10% DMSO.
> - Steve N
>
> ----- Original Message -----
> From: Leslie <[email protected]>
> To: [email protected] <[email protected]>
> Sent: Wed Nov 25 17:40:39 2009
> Subject: Re: CS>Use of high ppm CS
>
> Is silver citrate when you overcook as the 200 PPM?? My grandson has
some infected teeth and has had a time. I had recommended peroxide as
well as CS but didn't seem to take care of it.
>
> Leslie
>
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Instructions for unsubscribing are posted at: http://silverlist.org
To post, address your message to: [email protected]
Address Off-Topic messages to: [email protected]
The Silver List and Off Topic List archives are currently down...
List maintainer: Mike Devour <[email protected]>
