Hey you guys with the Colloid Master having trouble need to call Pearl or
Steve, At http://www.wishgranted.com
I never did make a Quart at a time, I started with a gallon glass large mouth
jar,
(4 quarts) similar to an Ice tea jar. Cut Slots in the lid to hang silver
rods,strips or coins, & a hole to put an air mixer hose. In the 12 years I only
have bought two bubblers,(with air filters and control valve on the hose ) they
both still work well. I have had my Colloid Master for over 12 years, and never
one problem with it, it takes over night to make a gallon with silver strips,or
2 one ounce Canadian $5.00 silver maple leaf coins, that are now sold for
aprox $24.00 each. PS Make sure your jar is clean, Wipe it out with a coffee
filter, {no lint} cheaper than paper towels too. Also make sure your power
switch is on normal (up) not the Fast one (down) Call the mgf at web site above
They will walk you through it.
If you can't make perfect Colloidal Silver with a colloid master your doing
something wrong? Or there is something wrong with the unit, They would replace
it if there is.
Tel Tofflemire
Dewey, AZ.
http://www.quailwoodherbal.com
________________________________
From: MaryAnn Helland <[email protected]>
To: [email protected]
Sent: Fri, February 26, 2010 2:29:23 PM
Subject: Re: CS>Colloid Master??
That's really odd, Pat. Mine rarely takes more than 5 or 6 hours. My CS is
always clear, and I never have any crud on the bottom of my jars. I don't
worry a bit about the electrodes being straight and parrallel -- more that
they're not touching. Do you use a quart Mason jar? You only have to hook the
electrodes over the lip of the jar. And I use a pair of electrodes about a
year too -- but I make CS several to many times a week. That crud on the
bottom of your jar is the remains of the electrodes that are being eaten up. I
brew mine in the kitchen -- but I drape a kitchen towel over the jar, as much
to keep the electrodes in place on opposite sides of the brewing jar as to keep
the water clean. I stopped worrying about light a long time ago.
MA
________________________________
From: Pat <[email protected]>
To: [email protected]
Sent: Fri, February 26, 2010 2:50:57 PM
Subject: Re: CS>Colloid Master??
My Colloid Master AC has a green light that goes on and off while brewing, then
turns off totally when it's finished. The red light stays on to indicate it
has power plugged in (although I think it goes on and off, too during brewing.)
Sometimes it takes 12 hours or more. I keep it in the dining room, so don't
look at it often. It leaves quite a bit of crud on the bottom of my jars. The
CS is clear as long as I don't go above 5.5. The worst thing about the machine
is that it's hard sometimes to get the electrodes straight and parallel when
I'm putting the clips on. It eats them up, too, sometimes. I'm on the third
set in four years and I don't make it very often.
My daughter loves her Silver Puppy. My Colloid Master said to not brew in the
light, though, so I was wondering about the warming light with the Silver
Puppy. Does light during brewing make a difference?
Pat
________________________________
From: Golden Aldi <[email protected]>
To: [email protected]
Sent: Fri, February 26, 2010 2:49:34 PM
Subject: Re: CS>Colloid Master??
My setting is at about 5.5 or 6 to get a 10 ppm. I can't tell if it shuts
itself off or not, but I'm hoping it does, and its the other light, the red
one, that doesn't go on when it stops, which it should, according to the
instructions that came with the generator. If the generator does go off, then
maybe completely, which would explain why the red light does not go on. *grin*
Aldi
O
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Rules and Instructions: http://www.silverlist.org
Unsubscribe:
<mailto:[email protected]?subject=unsubscribe>
Archives:
http://www.mail-archive.com/[email protected]/maillist.html
Off-Topic discussions: <mailto:[email protected]>
List Owner: Mike Devour <mailto:[email protected]>
