I had similar problems with my new Distiller,I double distill for best results.Also,I lowered the level of the water in the tank by about 1 cm.This prevents boiling expansion of H2O from spilling over into the condenser coil.When I just want topical EIS,I distill once.But if I run short of good,I will take this one orally.not in large amounts though.
Harold ----- Original Message ----- From: Asif Nathekar To: [email protected] Sent: Saturday, June 18, 2011 3:48 PM Subject: CS>home made CS generater Hi, i made a post three weeks ago, to which many kind people helped regarding building my CS generator. it was built using a LM317T chip to control current at 1.5ma to three anodes and three cathodes, total area squared of anodes is 3 inches (thin silver wires). And Voltage at 30v initially. I was getting large visible particles of silver coming of the electrodes, with the kind help of the people on Silver-list I was able to work on some possible causes namely. 1: Electrodes were too close, they were 3 cm apart, they are now 5 cm (2 inches) apart. 2 : Water provided was some how contaminated, I bought my own water distiller and am able to eliminated that (0 ppt, 0 microseimens) 3 : Paper towel was used to clean the cathode, now using green plastic scouring pads (no detergent) 4 : Contaminated brewing vessel , I cleaned with no detergent, and rinsed with distilled water, distilled water in brewing vessel tested 0 microseimens. I have implemented these changes, however I am still getting similar results as before, meaning visible particles of silver, but massively reduced amount of crap at the bottom of the jar. when the electrodes are dipped into the freshly distilled water it conducts 1.2ma immediately... which eventually gets to 1.5ma, and I have a voltage of 30v across which when dipped into the fresh water measures 14v immediately (of course the voltage is being reduced to keep the current at 1.5ma).. Which means its conductive... but measures 0ppm, 0 microseimens! any suggestions?... p.s. when it gets to 8 volts it tests at 5 microseimens. so its doing something!.. Its currently at 7.3V and tests at 7 microseimens.
