I have a "Multidetector II Profi" "High Sensitive Electrosmog-Analyser"
It has EMF scales from 1 MV/Meter to 1000 MV/Meter and frequency bands for
below 500 Hertz and also above 500 hertz.
It goes off scale on about half the ranges most anywhere in my house. Of
course it's seeing the fields from the house wiring and there's no way to
see microwave energy from the Power meter. It's all the same.
Go figger.
Trem
----- Original Message -----
From: "Marshall" <[email protected]>
To: <[email protected]>
Sent: Monday, October 24, 2011 9:31 AM
Subject: Re: CS>Smart Meter Frequency and Info
I am not sure they would tell you anything. My K2, which is similar goes
off scale near even the analog ones.
Marshall
On 10/23/2011 11:23 PM, Dan Nave wrote:
I don't know. You could read up on it or just try it.
Dan
On Sun, Oct 23, 2011 at 8:05 PM, Craig Chamberlin
<[email protected]> wrote:
Hi Dan,
Would a tri-field meter be able to pick up these emissions? I have one,
but
need to buy a nine volt battery for it, as I am out, *sigh*.
Thanks,
Craig
Dan Nave wrote:
Found some useful info at this link. Below the part I attached is
also a list of links that may be relevant.
Dan
http://www.sdge.com/smartmeter/faq.shtml
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Rules and Instructions: http://www.silverlist.org
Unsubscribe:
<mailto:[email protected]?subject=unsubscribe>
Archives:
http://www.mail-archive.com/[email protected]/maillist.html
Off-Topic discussions:<mailto:[email protected]>
List Owner: Mike Devour<mailto:[email protected]>
