Hi Ode and Marshall, The medics use a conductive electrode gel with silver/silverchloride . This is used for longterm connection called resting electrodes. I used them a lot for the Bob Beck type units because they helped to prevent the skin burning which I thought due to a better skin connection. The burns always seemed to be at point contacts.
Grist ? Tony On 27 Dec 2012 at 11:40, Marshall wrote about : Subject : Re: CS>OT - zapper burns > I believe this is a correct analysis. It might be worth while figuring > out something that can be added to the water that will increase > conductivity and not produce such corrosive chemicals. Any salt, acid or > alkaline will work. I was thinking of either vinegar (acetic acid) or > citric acid. I believe that hydrogen will be released at one electrode > and CO2 at the other. The CO2 is probably not a problem, it will make > carbonic acid, but the hydrogen will quickly react with most metals making > a metal hydride. So the choice of electrode material will be important. > > I am looking at the pads on a TENS unit. They appear to have a carbon > conductive layer, and you use some type of gel with it. Carbon would be a > good choice if made like they are in the TENS unit. > > Marshall > > On 12/27/2012 8:37 AM, Ode Coyote wrote: > > The problem is that the electrochemicals being produced build up in the > > skin because the skin doesn't have much blood flow rate to dilute them > > as fast as they are being made. Those are "chemical" burns. 5 ways to > > prevent..can all be used at once or any in part. > > > > Reduce voltage [potentiometer] > > Reduce electrolyte conductivity..ie dilute it with more water [does the > > same thing as the pot, but in a different spot] Increase electrode pad > > area to spread concentration of electro chemicals over a larger volume > > of blood flow. Use zapper for a few minutes and take a few off. Switch > > polarity to neutralize that particular electro-chemical with it's > > opposite. > > > > Ode > > > > > > > > > > If one applies a DC current to a bucket of salt water, it will split > > into Hypochlorous Acid and Sodium Hydroxide.[ an alkaline base...aka LYE > > ] That substance was being promoted as a super duper house hold > > cleaner...with a very short shelf life. > > > > The Hypochlorous Acid is a grand disinfectant. > > The Sodium Hydroxide, a great de-greaser [like Formula 409 ] > > > > Then, there is MMS [ "Miracle Mineral Supplement"...which looks like > > everything BUT that, having nothing to to with supplementing minerals > > ] made from Sodium Chlorite being used to get rid of parasites and > > germs in the blood stream..easy enough to over dose on and make you feel > > really ill. [Careful there] > > > > THEN..there is the Godzilla Zapper, a very simple and cheap device that > > can be made using junk around the house...used for "blood > > electrification". > > > > http://health.groups.yahoo.com/group/microelectricitygermkiller/ > > > > BUT > > > > Electricity doesn't flow through a conductive liquid like it would a > > metal wire, it transports electrons via chemical reactions > > ....."Electro-chemistry" > > > > SO > > > > The Zapper cannot be working by the method claimed...but there is much > > that indicates that it does work. How could that be?!!! > > > > OK > > > > So what is the human body but a bag of salt water ? [rather than a > > bucket of salt water] > > > > If one electrode is Alkalizing and the other is Acidifying and you get > > salt when the two chemicals meet up and recombine, what could that > > potential be used for? > > > > 1] You have a MMS analog with it's own antidote being produced in vivo > > using a simple Zapper. [ A couple of AA batteries, some wire and a > > couple of sponges soaked with salt water] ....too much? [burning and > > itching??] Turn it down or shut it off. [let the build up dissipate] > > > > 2] You have an Alkaline situation at the OTHER electrode being made in > > vivo ....with ITs antidote lurking just around the bend...... > > > > Both made from existing salt, going back to salt. > > > > That's chemo therapy with immediate dosage control and location > > control as well...and no toxins left over after recombination. > > > > > > At 11:58 AM 12/26/2012 -0800, you wrote: > >> Hi, > >> Although I wrapped the copper handholds in a layer of wet paper towel I > >> ended up with a burn on the side on which I felt the estim most. I'm > >> used to working with units that have an amplitude adjustment and this > >> zapper does not. I was running 15 Hz. > >> > >> Would someone tell me what I can do to avoid this happening again. It > >> happened once before so I know from experience that they take awhile to > >> heal. > >> > >> Thanks. > >> PT > > ------------------------------------------------------------------------ > > > > No virus found in this message. > > Checked by AVG - www.avg.com <http://www.avg.com> > > Version: 10.0.1430 / Virus Database: 2637/5490 - Release Date: 12/27/12 > > > > -- The Silver List is a moderated forum for discussing Colloidal Silver. Rules and Instructions: http://www.silverlist.org Unsubscribe: <mailto:[email protected]?subject=unsubscribe> Archives: http://www.mail-archive.com/[email protected]/maillist.html Off-Topic discussions: <mailto:[email protected]> List Owner: Mike Devour <mailto:[email protected]>
