On Fri, 12 Nov 1999 23:40:19 -0500, "Jeffrey A. Madore" <[email protected]>
wrote:

>I plan to melt them on a sheet of stainless, using an oxy acet torch.
>Can anyone tell me if this would cause contamination of the silver,
>such that it would not be optimum for CS generation? Would there
>be a better material to use to accomplish this process? My initial
>experiments showed that the stainless got cherry red as the silver
>reached a temp where it would flow. Possibly I just need to heat it
>more slowly.

Silver melts at 1762 degrees F, Stainless Steel at 2500 F.
I don't see how any contamination would occur.

                                                        Chuck
Beam me up, Scotty, it ate my phaser


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]

List maintainer: Mike Devour <[email protected]>