So does this mean it is ok to melt silver on a stainless steel surface? Someone mentioned pyrex. Would that take the heat without cracking? I tried a glazed ceramic tile and ended up with broken-tile-silver-soup!
Jeff (How will you spend eternity -- Smoking or Nonsmoking?) Trem Williams wrote: > Sorry Dennis but you're wrong too. The miners used mercury to amalgamate > the gold. That means to make the gold stick to the mercury or vice versa. > They would rub a generous amount of mercury on clean copper sheets and place > the sheets in their sluice boxes. When the gravel, sand, mud and water > passed through the box, the gold and any noble metals would stick to the > plate. At the end of the day they would then remove the plate and use a > squeegee to wipe the gold and other metals stuck to the mercury off the > plate. They would then wring the mercury out through a sheet of chamois. > The mercury would pass through the chamois leaving the metal in an > amalgamated lump in the chamois. They would then drive the mercury off the > lump by using heat and what was left was the metal that had been trapped in > the mercury. They then separated the gold from other metals using different > techniques. One of the basic ones was to heat the metal lump in a crucible > with some antimony. Antimony is called the wolf in alchemical terms. That > is because it eats all metals EXCEPT gold. It flies off in the form of > dense white smoke and carries all metals except gold with it. The gold left > behind is considered pure. If there was a lot of silver in the mix, they > would use other processes to get it and would not use antimony because the > silver would be lost. But if there was little metal other than gold, the > antimony process was favored for it's simplicity. > > Gold and all noble metals stick to mercury; they do not dissolve in mercury. > They can always be > separated from mercury by heat. It's called distillation if you recover the > mercury. It's called > "flashing off" if you let the mercury go into the atmosphere. > > Hope this clears the subject up to your satisfaction.

