Sharon I get this black smudge or patch on the bottom of the jar too. It comes from the cathode (-) wire. I notice that if the solution is left overnight or longer, most of it disappears. I just wipe off the rest with a paper towel when I transfer the solution. Never got around to asking Ivan about it. wong
In a message dated 12/10/1999 7:44:38 AM Pacific Standard Time, [email protected] writes: > I use a one quart jar when making my CS. I have holes in the center of the > lid where I hang my silver rods. It isn't long before a blackish smudge > appears at the bottom of jar. When it gets to where I think it needs to be > cleaned out, it takes a little scrubbing to remove it. I'm always VERY > careful to wash and rinse rinse rinse the jar before using it again, > including a final rinsing in distilled water. When I used to hang the rods > over the sides of the jar, the blackish smudge appeared on the side by the > rods. Is that fallout or plating? > > Thanks, > > Sharon -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>
